6ft veneer peeling machine

The non-card rotary cutting machine is mainly used to cut wood core or small-diameter wood into veneer. The main components include: frame, double-roll system, single-roll system, tool holder, transmission system, electrical system, etc.

The rotary cutting machine has the following advantages:

1. Computer control, high accuracy;

2. Made of high-quality steel, with long service life;

3. The machine runs smoothly and safely;

Linyi Guoyu Machinery Co., Ltd. is mainly engaged in rotary cutting machines, round finding machines, complete sets of equipment for wood industry, and rotary cutting machine assembly lines. The types of rotary cutting machines are: with card, without card, and automatic rotary cutting machines; All kinds of peeling rounder and wood rounder.

Use principle of non-card rotary cutting machine:

1. When setting the minimum processing remaining wood segment for the non-card rotary cutting machine, the minimum setting value should not be less than 30mm, otherwise it is easy to cause machine failure.

2. When setting the stop point, the upper limit of the set value shall not exceed the maximum travel of the equipment, and the lower limit shall not be less than the set value of the processing surplus, otherwise the machine cannot work.

3. The rotary cutting machine should be used within the scope of use specified by the technical characteristics. Some manufacturers use it to cut plastic for the sake of convenience, which leads to serious deformation of the plastic and also damages the use of the peeling machine, so don't think of using multiple machines.

4. After each use of the rotary cutting machine, the waste materials above and below should be removed to prevent the machine from getting stuck, and at the same time, the rotary cutting efficiency and the service life of the machine will also be affected.